Webster IRP 5100 Uživatelská příručka stáhnout pdf (Strana 21)

the face of the lower spindle. Position the V slot of the spacer

down and to both sides of the spindle to take up the slack

space.

13 Apply the magnetic whiteboard icon strip to one of the four

corners of the board.

14 To enable and specify the location of the icon strip, ﬁrst install

the Webster software as described (refer to “Installing Webster

Software” on page 18) and then refer to “Customizing General

Options” on page 79 for instructions on telling the software

where the icon strip is located.

To mount your whiteboard on an optional mobile stand, see the

instructions included with your mobile stand or visit

www.polyvision.com.

Connecting Your Webster LT Whiteboard

Ensure that both your computer and whiteboard are powered off

before you make connections.

To connect the whiteboard to your computer:

1 Plug the AC power cord into the connector on the bottom of the

whiteboard, next to the serial port.

2 Plug the power cord into an electrical outlet.

rear view

Webster_draft2.book.mif Page 15 Friday, October 11, 2002 10:07 AM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 114 115

Žádné komentáře

Webster IRP 5100 Uživatelská příručka Strana 21